Skip to main content

09 Jacdaptor

Jacdaptor.png​

Module Introduction​

jacdac27.png

  1. Microbit Edge Connector
  2. Jacdac Standard Through Hole
  3. Micro:bit Gold Finger Pad (P0, P1, P2, 3V3, GND)
  4. Power Switch
  5. Jacdac Interface
  6. Micro:bit Full Interface Out (convenient for Maker welding)
  7. Product QR Code

The function of the switch​

  • When the switch is at the bottom, the power is supplied from Micro:bit to Jacdac interface (commonly used mode, only need to supply power to Microbit with data cable, Jacdac module can work normally)

jacdaptor开关2.png

  • When the switch is at the top, the power is supplied from the Jacdac interface to Micro:bit (if you have an external power input, you can use this mode)

jacdaptor开关1.png

FAQ​

Q1 ：Can Jacdaptor be adapted to MicorbitV1.5?​

A1：Jacdaptor can only be used with MicrobitV2

Q2：What is the voltage of Jacdaptor?​

A2：5V

Q3：Which mode should the Jacdaptor power switch choose?​

A3：It is recommended to switch the switch to the bottom and use Micro:bit to supply power to the Jacdac interface